![]() ![]() Sir, kindly help me with the above problem. Exactly which value I should refer workbench interface principal stress results or PRNSOL command results? Why? How the principal stresses are calculated in ANSYS for both PRNSOL command and the workbench interface principal stress results?ģ. Why there is difference between exported results and the results by command?Ģ. ![]() Currently Im running an analysis with several design points, which need certain post-processing. ![]() Im using workbench, therefore Im not really familiar with APDL code. I found that the selection by the NSEL command is validated by the results by command and not by the results which are exported by the averaged maximum principal stress in ANSYS Workbench Interface.ġ. Hi everyone, Im trying to write a command to save a certain result set as txt-file automatically after the analysis. output,line_bodyS1,TXT ! Redirect results to fileĪfter solving this, I exported the maximum principal stress given by the result tool in ANSYS Workbench and compared with the results printed by the command. GRAPHICS,POWER ! Define the type of display Seltol,1e-12 ! tolerance for selection is minimised SET,1,5 ! Read first load step 5th substep I used following commands to print the principal stress results. After this I wanted to see which nodes are selected by this command so i referred your answer 2 years ago on Abhinay Ojha's question where you have answered to get the principal stresses by command. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |